SATO CL412E Printer User Manual


 
Special Notes 1. Use of this command will set the Vertical/Horizontal Offset setting
of the printer configuration until a new Base Reference Point
command is issued or the setting is changed from the operator
panel. See Section 3: Printer Configuration.
2. This command may be used more than once in a print job.
3. An alternative to using this command is to make changes to your
current Horizontal and Vertical Print Position commands.
Example:
Let’s say the current base reference point is H=1, V=1 and you
wish to move all the fields on your label downward vertically by
150 dots. You could either (1) add the Base Reference Point
command or (2) change all the vertical position commands by an
additional 150 dots.
4. For a more detailed example of the Base Reference Point
command, see “Print Area” in this section.
5. The “Se” print engines can print as close as 2 mm to the inside
edge of the label.
6. The “Se” print engines will not “wrap” (i.e. if any part of a character
or image extends beyond the last print dot position, it will
disappear and not be visible on any part of the label).
7. The allowable field ranges for this command are:
CL408e CL412e CL608e CL612e
Horizontal
aaaa -832 to 832 -1248 to 1248 -1216 to 1216 -1984 to 1984
Vertical
Default
bbbb
Expanded
bbbb
0001 to 1424
0001 to 9999
0001 to 2136
0001 to 9999
0001 to 1424
0001 to 9999
0001 to 2136
0001 to 9999
Page 5-20 PN 9001074 Preliminary SATO CL Series “e” Printers
Section 5. Programming Reference