Filter
Top Products
Faxing
32
2
Immediate Transmission
With Immediate Transmission, when
you press the {Start} key, the fax
number is dialed immediately. The
message is scanned and transmitted
page by page without being pro-
gramed in memory. This contrasts
with Memory Transmission which
scans all pages into memory before
dialing the destination.
Immediate Transmission is useful if
you want immediate confirmation
that the message is being sent to the
correct destination (just check for the
other terminal's Own name or Own
Fax Number on the operation panel
during transmission).
Note
❒ You cannot send the same message
to multiple destinations (Broad-
casting). Use Memory Transmis-
sion for this purpose.
❒ Place the original on the exposure
glass or in the Document Feeder
(ADF). To send two or more pages
from the exposure glass, set them
one page at a time.
❒ You can scan some pages of your
original from the exposure glass
and the remainder from the Docu-
ment Feeder (ADF). When you
have finished scanning from the
exposure glass, place the remain-
der of the pages in the Document
Feeder (ADF) and press the {Start}
key within ten seconds.
❒ By default, the transmission mode
selected when the machine is
turned on or when modes are
cleared (transmission mode home
setting) is Memory Transmission.
You can change this with the [Gen.
Settings/Adjust] key. ⇒ Chapter 7,
"General Setting/Adjustment" in
the Advanced Features manual
A
Make sure that Immediate Trans-
mission is selected.
If it is not selected, press the
[Immed. TX] key.
B
Set the original.
Limitation
❒ Do not open the Document
Feeder (ADF) while it is scan-
ning the originals. This can
cause originals to jam.
Note
❒ The original can be placed at ei-
ther Document Feeder (ADF) or
Exposure Glass, until you press
the {Start} key.
Reference
P.16 “Setting Originals”
AdonisC2_EN_b-f_FM.book Page 32 Tuesday, January 23, 2001 4:45 PM