Filter
Top Products
Original Orientation and Scan Area
37
3
C
CC
C
Press [OK].
Note
❒ The current settings are dis-
played with characters and
icons.
For a Network TWAIN Scanner
A
AA
A
Open the [Scanner Properties] dia-
log box.
Reference
p.76 “Scanning Originals”
B
BB
B
Select the position from the [Docu-
ment:] list in the [Document] area.
C
CC
C
Select [ / ] or [ / ] from
the [Orientation:] list.
Reference
p.31 “Specifying Original Ori-
entation and Setting Originals”
D
DD
D
When the originals are placed in
the ADF, select [Simplex] or [Du-
plex] from the [Side:] list.
Note
❒ If originals of different sizes are
placed in the ADF, specify the
document size or detection
method in the [Size:] box. If [Au-
to detection (Uni-size)] is selected,
all originals are scanned as their
widths are considered the same
as the size of the first page. If
[Auto detection (Multi-size)] is se-
lected, the originals are respec-
tively scanned in accordance
with each page width. And, the
size range for scanning origi-
nals in forwarding direction
corresponds to the length of in-
dividual page to be fed (to the
ending edge) in both cases of
Multi-size and Uni-size.
Scanning Originals in Several
Times
A large number of originals can be
scanned as a single document by di-
viding them and scanning them indi-
vidually or in batches using the
exposure glass or the ADF. Select [On]
in [Job Reset Time in Adding Original],
and then specify a job reset time. If
another original or batch of originals
is placed within this time after all pre-
viously placed originals have been
scanned, it is possible to scan all of
these originals as a single document.
Reference
p.18 “Job Reset Time in Adding
Original”