Filter
Top Products
Getting Started
36
1
❒
Set documents with pencil writing
on the back in the document by-
pass tray.
❒
Do not set a stack of documents
containing pages of different
width in the Auto Document Feed-
er (ADF).
❒
Do not open the Auto Document
Feeder (ADF) while it is scanning
the documents. Otherwise, docu-
ment will be jammed.
Note
❒
Set documents more than 23.7"
(600mm) long in the Document By-
pass tray.
❒
If your document is bent or folded,
flatten it before you set it.
Reference
For information about the sizes
and number of documents that can
be placed in the Auto Document
Feeder (ADF), see P.32
“Acceptable
Types Of Documents”
.
A Adjust the document guide to
match the size of your documents.
B Align the edge of your documents
and stack them in the Auto Docu-
ment Feeder (ADF) face up.
Setting Paper in the Document
Bypass Tray
Set your document in the document
bypass tray if it falls under any of the
following categories:
• It is longer than 23.62" (600mm)
• The front side is shiny of smooth
• The rear side is written in pencil
Limitation
❒
The machine can scan documents
up to 47.24" (1,200mm) long.
❒
You can only set one page at a time
in the document bypass tray.
❒
Do not set another document in the
Auto Document Feeder (ADF )
while a document is being scanned
from the document bypass tray or
a jam could occur.
A Open the document bypass tray
in the direction of the arrow.
B Adjust the document guides to
match the width of your docu-
ment. Then set your document
with side you wish to send face-