Sharp AR-157E All in One Printer User Manual

This chapter explains basic and other copying functions.
The unit is equipped with a one-page memory buffer. This memory allows the unit to
scan an original once only and make up to 99 copies. This feature improves
workflow, reduces operation noise from the copier, and provides higher reliability by
reducing wear and tear on the scanning mechanism.
If the unit does not function properly during use, or if a function cannot
be used, see "TROUBLESHOOTING THE UNIT" (p.30).
1 Make sure that paper has been loaded in the paper tray (p.8)
or multi-bypass tray (p.10), and check the paper size (p.7).
If paper is not loaded, see page 8.
2 Turn on the unit (p.13).
3 Place the original.
If you are using the original table, see "Using the original table" (p.14).
If you are using the RSPF/SPF, see "Using the RSPF/SPF" (p.15).
When copying onto paper larger than 8-1/2" x 11" size, pull out the paper
output tray extension.
5 Start copying.
Press the start ( ) key.
4 Select the copy settings.
If you wish to copy using the initial settings (p.13), proceed to the next
To set the number of copies, see page 16.
To adjust the resolution and contrast settings, see page 16.
To enlarge or reduce the copy, see page 18.
To change the tray, see page 19.
To print on both sides of paper, see page 20. (AR-157E)