Sharp AR-157E All in One Printer User Manual


 
31
6
STATUS INDICATORS
When the following indicators light up or blink on the operation panel or the following
alphanumeric codes appear in the display, solve the problem immediately referring
to both the table below and the relevant page.
Be sure to use only genuine SHARP parts and supplies.
Indication Cause and remedy Page
Developer
replacement
required indicator
Steadily
lit
Developer is required. Contact your SHARP
service center as soon as possible.
37
Toner cartridge
replacement
required indicator
Steadily
lit
Replacement of toner cartridge will be needed
soon. Prepare a new cartridge.
25
Blinking
Toner cartridge must be replaced. Replace it
with a new one.
25
Misfeed indicator Blinking
A misfeed has occurred. Remove the misfed
paper referring to the description of "MISFEED
REMOVAL".
32
The lower side cover may be open. If so, close it. 35
Maintenance
indicator
Steadily
lit
Service by an authorized SHARP service
technician is required.
37
RSPF/SPF misfeed
indicator
Blinking
An original misfeed has occurred in the RSPF/
SPF. Remove the misfed originals referring to
the description of "E: Misfeed in the RSPF/SPF".
35
Power save indicator is
steadily lit.
The unit is in the preheat mode. Press any key to
cancel the preheat mode.
22
The unit is in the auto power shut-off mode.
Press the start ( ) key to cancel the auto power
shut-off mode.
22
The paper tray indicator is
blinking.
The paper tray is not installed properly. Push the
tray into the unit securely.
8
"CH" is blinking in the
display.
A toner cartridge is not installed. Installed a toner
cartridge. If "CH" is blinking even if a cartridge is
installed properly, contact SHARP service
center.
25
"CH" is steadily lit in the
display.
Side cover is open. Close the side cover
securely by pressing the round projections near
the side cover open button.
"P" is blinking in the display.
The paper tray or multi-bypass tray is empty.
Load paper.
8, 10
A misfeed has occurred in the paper tray, multi-
bypass tray. Remove the misfed paper.
32
A letter and a number appear
alternately.
The unit will not function. Turn the power switch
off, remove the power cord from the outlet, and
contact your SHARP service center.