Sharp AR-157E All in One Printer User Manual


 
32
MISFEED REMOVAL
When the misfeed ( ) indicator blinks or blinks in the display, the unit will
stop because of a misfeed. If a misfeed occurs when using the RSPF/SPF, a number
may appear in the display after a minus sign. This indicates the number of the
originals that must be returned to the original feeder tray after a misfeed. Return the
required number of originals. Then this number will disappear when copying is
resumed or the clear ( ) key is pressed. When the RSPF/SPF misfeeds an
original sheet, the unit will stop and the RSPF/SPF misfeed ( ) indicator will blink,
while the misfeed ( ) indicator will remain off. For a misfeed of originals in the
RSPF/SPF, see "E: Misfeed in the RSPF/SPF" (p.35).
1
Open the multi-bypass tray, and side cover, in that order.
To open the multi-bypass tray, see "BYPASS FEED (including special
paper)" (p.10). To open the side cover, see "TONER CARTRIDGE
REPLACEMENT" (p.25).
2
Check the misfeed location. Remove the misfed paper
following the instructions for each location in the illustration
below. If the misfeed ( ) indicator blinks, proceed to "A:
Misfeed in the paper feed area" (p.33).
If the unit is turned on with the lower side cover open, the misfeed ( )
indicator will blink. In this case, close the lower side cover. The misfeed
( ) indicator will go out.
If paper is misfed here, proceed to "A:
Misfeed in the paper feed area". (p.33)
If paper is misfed here, proceed
to "D: Misfeed in the lower
paper feed area". (p.35)
If paper is misfed here, proceed to "B:
Misfeed in the fusing area". (p.33)
If the misfed paper is seen from
this side, proceed to "C: Misfeed
in the transport area". (p.34)