Sony DVS-A3232 Switch User Manual


 
2-13
ROUTING SWITCHER SYSTEM (E)
2-17. Route Function
1234 678
1234
IN
OUT1
OUT2
5678
Expanded input (Source of swithcer B)
DVS-7000 (Level 1)DVS-V6464B (Level 1)
Switcher A Switcher B
Expanded input selection buttons
Selection buttons
OUT2 controlling panel
Phantoms are set to these button.
IN1 : OUT1 < IN1
IN2 : OUT1 < IN2
IN3 : OUT1 < IN3
IN4 : OUT1 < IN4
As OUT1 is included in switching setup data,
OUT2 < IN5 is switched automatically by Route function.
(Source of switcher A)
(Destination of switcher A)
IN
(Destination of
switcher B)
2-17. Route Function
One of an application of Router is to expand number of Source inputs for DVS-7000 connecting with
DVS-V6464B, show below.
Route function is to display a source input chasing from a last program out even performing 4 times Re-
entry function with DVS-7000/DME. To display the actually selected source name, you must set the
route function with the control terminal. Then when you select the crosspoint set on the route function,
the source on the switcher A is searched for and the name is displayed. For example, when a crosspoint is
switched on the switcher A in the figure below, normally IN5 appears as the source name. If the route
function has been set, the source name selected on switcher A appears.
To activate the route function, set the destination of switcher A, destination and source of switcher B, and
level. In case of the figure below, set “OUT1 : OUT2 < IN5.”
When you use the route function, switching is possible with simple setting. For example if you select a
source (IN1) for a destination (OUT1) on switcher A , the crosspoint on switcher B (IN5-OUT2) is
automatically switched.
On the other hand, when you select a source (IN1) for a destination (OUT2) on switcher A, you have to
set a phantom, IN1 : OUT1 < IN1 previously. Then IN1-OUT2 is displayed if the phantom; IN1 is
selected.