Filter
Top Products
4-3
ROUTING SWITCHER SYSTEM (E)
*1 : Set the P/S switch of the BKPF-R70 board to “P” position.
*2 : Use the cross-cable with 9-pin (female) and 9-pin (female) connectors for BKPF-R70.
*3 : Data transfer speed of BKPF-R70 is 38400 bps.
4-3. Preparation Before Setup
4-3. Preparation Before Setup
1. Set a primary station
DVS-V6464B or DVS-V3232B is recommended as the primary station.
Set M/S switch on the CPU-149 board to “M” position
*1
.
Station ID automatically will equal one.
n
Set only one primary station.
If more than two are set as the primary, they will not work correctly.
2. Connect PC
Connect a IBM compatible PC with MS-DOS Ver. 6.2 to the Remote 3 on the primary, using RS-232C
cross-cable with 25-pin (male) and 9-pin (female) connectors
*2
.
Run terminal emulation software and communicate at 9600 bps
*3
.
The Terminal program associated with Windows 3.1 allows the mapping of control strings to virtual
function keys in the terminal program. Therefore, if your are using Windows 3.1 you can use it’s Termi-
nal program. Windows 95, and Windows NT have terminal emulation programs which do not have this
feature. If you are using a PC with Windows 95 or Windows NT, you must use a third party terminal
emulation program that allows control strings to be mapped to keys on the keyboard (usually the F1
through F12 function keys).
3. Turn on the power
Turn on the power of all equipment connecting on the S-BUS line.
n
Operation of the routing switcher may be unstable just after the power is turned on. Wait about one
minute of warm-up before starting the setup.