Sony UP-51MDU Printer User Manual


 
76
Installation and Adjustment
When connecting the video monitor to the RGB SYNC OUTPUT
connectors
Normally, set SYNC ON G in the OUTPUT SETUP menu to ON.
Set SYNC ON G to OFF in the following case: If the images displayed on the
video monitor become greenish, compared with the printout, adjust the video
monitor color (set the adjusted value of the video monitor color to the default). (See
Matching the Video Monitor Color to the Printer Color on page 83.) If the
images on the video monitor are still greenish, set SYNC ON G to OFF.
Making Connections to Enable Remote Control
The printer can be controlled remotely by connecting an RM-5500 Remote Control
Unit (not supplied), RM-91 Remote Control Unit (not supplied), an FS-30/FS-36
Foot Switch (not supplied) or a personal computer.
a) When connecting a personal computer, select the appropriate baud rate from the SYSTEM
SETUP menu. (See Setting the Baud Rate for Computer Communication on page 113.)
b) You can also connect an FS-36 foot switch.
c) You can also control the printer remotely by sending the signal to pin No.5 of the REMOTE 3
connector.
B
A
C
Computer
a)
to RS-232C
to REMOTE 1
to REMOTE 2
t
o
REMOTE 3
RM-91 (not supplied)
b)
RM-5500 (not supplied)
FS-30 (not supplied)
c)
RS-232C cable
to AC IN
to wall outlet
AC power cord
(supplied)
Connections (Continued)