Filter
Top Products
12
Delta User’s Manual
.~
-
-- -
-
Figure l-11. The perforation should be lined up with the top of the ribbon guide.
To use Delta-15 this way, you’ll need to install the tractor unit,
the paper separator, and the paper guide if you haven’t already. If
you’re unsure how to do it, see Appendix A and Figure l-8.
-
The steps for bottom loading Delta-15
1. Turn the power switch off and remove the printer cover.
2. Pull the release lever to position “T” (Figure l-4).
-
3. Raise the paper press bar.
4. Place the stack of sprocket-feed paper below the printer, ide- -
ally on a specially-built printer table with a built-in slot. -
5. Open the tractor covers, right and left (Figure l-9).
6. Flip the clamp levers forward. This allows the two sprocket
units to move freely right and left, so you can align them with
the holes in the paper.
7. Pick up the first “sheet” and lift it up and through the slot in
the bottom of the Delta-15.
8. Push the paper up to the front of the platen roller.
9. Feed the top sheet inside the paper press bar and past the pla-
ten, high enough so you can grip the paper from above the
printer.
10. Pull the paper up past the sprocket wheels.
11. When the holes fit snugly over the nubby teeth, close tractor
covers and snap the clamp levers back into the locked posi-
tions.
-
_
-