Star Micronics Delta Printer User Manual


 
48
Delta User’s Manual
-
paper n lines (using whatever the current line spacing is) without
moving the printhead. Change line 30 of your program so that it is
like this:
3@ LPRINT CHR$(27) "a" CHR$(3);
-
-
Now when you run the program the results will look like this:
-
LINE NUMBER 1
LINE NUMBER 2
-
-
LINE NUMBER 3
LINE NUMEEl3 4
-
The new line 30 moves the paper up 3 lines, but the printhead
doesn’t move. Therefore, line 40 prints its message starting in the
column that the printhead was left in at the end of line 20.
-
Forms Controls
-
We have seen how to control the spacing between lines on a
page. Delta also has commands that control the placement of
printing on the page, and even adjust for different size pages.
Form feed
The simplest forms control code is the form feed. Form feed is
CHIQ(12) and causes the printer to move the paper to the top of
the next sheet. Try it by changing line 30 to this:
-
38 LPRINT CHR$(12);
Before you run the program, turn your printer off and adjust
the paper so that the top of the sheet is even with the top of the
ribbon guide on the print head, then turn the printer back on. If
you don’t remember how to do this, review Chapter 1. When you
-
-
-