Filter
Top Products
Ifthepaperparkfacilitydoesnotappeartobeworkingcorrectly,checkthe
following:
Check
Possible remcxly
Is the paper release lever in
The paper release lever must be set to the ~ position
the ~ position?
after the fanfold paper has been parked.
Has the fanfold paper been
Make sure that the
POWERindicator comes on flashing
properly parked?
after the fanfold paper has been parked.
If textis beingprintedallon oneline,or withextrablanklines,checkthe
following:
Check
Possible remedy
Is the text all on the same
Carriage returns are not being expanded to
tine?
<CR> + <LF> pairs. Check the DIP switch setting and
correct.
Is text being printed with
I
Two line feeds are being printed. Either make your
extra blank lines?
software print just a carriage return or (if this is not
possible), settheAUTOLFto OFF withthe DIPswitch
setting.
Ifthepagelengthandmarginsarenotwhatisexpected,checkthefollowing:
I Check I Possible remedv I
Is the printing starting too
Use the Micro Feed facility to adjust the print position
high or too low on the page?
relative to the page.
Does the printer’s page
Use the DIP switch to setup the correct page length, or
lengthnotmatchthe physical
use softwiwecommands to do it.
page length?
94