Filter
Top Products
11
SECTION 5 : Installing/Removing Shipping Protection Materials
To prevent the product from being damaged in shipment, cushioning materials and fixing metal are
used to secure the internal parts to the unit. Make sure all those protection materials are removed
before use. For the future shipment, keep the fixing metal and packing (3 types) in the packaging
box along with packing materials.
To prevent the product from being damaged in shipment, install the shipping protection materials in
reverse order to the removal procedure.
The P-55 is a precision machine. Be careful not to drop or subject the unit to severe impact (it
weighs more than 22 kg).
This product internally reaches a high temperature when in use. Before installing the shipping
materials in the unit, leave it turned off for a while (1 hour) to cool it off completely.
Make sure the ink ribbon and transfer ribbon are removed when the shipping protection materials
are installed in the unit.
1. Peel off adhesive tape A from the top left of the unit and press unlock button B to open side door
C.
2. Loosen the screw
D and pull out the metallic bar E. Insert the removed metallic bar into position
marked
F to keep it for future use.
3. Peel off adhesive tape
G, flip up lock lever H to unlock the ribbon cartridge and remove two
cushions
I by pulling them toward you.
4. Pull out ribbon cartridge
J, remove cushion K and then put back the ribbon cartridge to its place
for the moment. (You may want to keep the cartridge removed to load ribbons as discussed later,
in SECTION 12 : Loading Ribbons.)
5. Flip down lock lever
H to lock the ribbon cartridge in place and lift up the side door until it locks.
Do not t
ry to forcibly close the side door without flipping down the lock lever, or the side door may
be da
maged.
NOTE
NOTE