Filter
Top Products
SECTION 14 : Getting Label Print Job Started
43
3) Correcting for aspect ratio
1) Place a medium on the tray and click Print next to
Aspect ratio on the Maintenance tab.
2) The P-55 starts printing the first test pattern.
*
The first test pattern is printed as shown on the left.
3) Take out the medium from the disc tray. Then, with
the medium rotated counterclockwise by 90
degrees, place the medium back into the tray so
that the two black printed areas on the medium are
set toward the printer side and aligned horizontally
as shown by the arrows.
*Move the medium to the right as shown by the red thin
arrows to bring the hold pins located into the center of
the tray into contact with the left side of the center
spindle hole of the medium.
4) Click Repeat on the Maintenance tab
.