Filter
Top Products
61
Getting Started
Installing additional memory (optional)
5.375 x 8.375 ver 2.4.1
CAUTION: Do not try to install a memory module under the
following conditions. You can damage the computer and the
module.
1. The computer is turned on.
2. The computer was shut down using Standby mode.
3. Power to the DVD-ROM or multi-function drive has been turned
on.
CAUTION: Do not install or remove a memory module while the
DVD-ROM or multi-function drive power is on.
You will need a standard Phillips No.1 screwdriver and a
small flat-head screwdriver to install a memory module.
CAUTION: To avoid damaging the computer’s screws, use a
standard Phillips screwdriver that is in good condition.
1 If the computer is on, turn it off.
See “Turn Off or Shut down command” on page 102.
2 Unplug and remove any cables connected to the
computer.
3 Open the display panel and remove the panel above the
keyboard that contains the power and TOSHIBA Console
buttons.
CAUTION: When removing the computer’s power and TOSHIBA
Console button panel to install additional memory, be careful not
to damage the display or circuit board.