Filter
Top Products
70
Getting Started
Connecting an optional Slim SelectBay module
5.375 x 8.375 ver 2.4.1
Please see “Inserting an optional hard disk drive into its
module” on page 72.
To install a Slim SelectBay module:
1 Save your work.
2 Turn off the computer via the Start menu.
3 Remove all cables connected to the computer.
4 Close the display panel and turn the computer upside
down.
5 Insert the module in the computer as shown below until
the release latch clicks.
Installing and locking the Slim SelectBay module
To lock a Slim SelectBay module:
1 Locate the Slim SelectBay lock screw and lock screw
holes next to the Slim SelectBay release latch.
2 Remove the Slim SelectBay lock screw from the hole for
the unlocked position (the hole closest to the back of the
computer).
3 Insert the screw in the adjoining hole for the locked
position (the hole closest to the front of the computer)
and tighten it.
Slim
Slim
SelectBay
lock
screw
SelectBay
release
latch
Slim SelectBay
lock screw holes