Filter
Top Products
2 SETTING ITEMS (ADMIN)
92 Setting General Functions
2
Specify the following items as required and complete the setting.
1) Press the desired period of time (in minutes) that this equipment should wait before the Sleep or Super Sleep
mode is activated.
2) Select whether this equipment enters the Sleep mode or the Super Sleep mode when a specified period of time
has passed. When [Enable] is selected, this equipment enters the Super Sleep mode.
3) Press [OK].
y The equipment may not enter this mode at the set timing depending on its operating status.
y This equipment does not enter the Super Sleep mode even if [ENABLE] is selected for this setting in the
following cases:
- A particular option (any of the Wireless LAN Module, Bluetooth Module and e-BRIDGE ID Gate) is
installed.
- The IPsec function (optional) is enabled.
- IEEE 802.1X authentication is enabled.
- IPv6 is enabled and the IPv6 address is not assigned manually.
- POP3 client setting is enabled and under any of the following conditions:
(1) The scan rate is set to other than 0 minute.
(2) A POP3 server address is entered.
(3) An account name is entered.
- In the network setting, ETHERNET is set to [AUTO (-1000MB)] or [1000BASE FULL] (Applicable only
for the e-STUDIO456 Series and e-STUDIO856 Series).
- A particular network protocol (AppleTalk or IPX/SPX) is enabled.
y When the equipment is under the above conditions, [ENABLE] or [DISABLE] of [SUPER SLEEP] cannot be
changed.
y For protocols available for recovering this equipment from the Super Sleep mode, refer to the TopAccess
Guide “Chapter 8: [Administration] Tab Page”.