Filter
Top Products
e-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE June 2005 © TOSHIBA TEC
2 - 4
E550 Other paper jam Paper remaining jam on the transport path: The
paper is remaining on the transport path when print-
ing is finished (caused by a multiple paper feeding).
Ch.5.1.4
E712 RADF jam Jam not reaching the original registration sensor:
The original fed from the original feeding tray does
not reach the original registration sensor.
Ch.5.1.6
E713 Cover open jam in the read ready status: Jam
caused by opening of the RADF jam access cover
or front cover while the RADF is waiting for the
scanning start signal from the equipment.
Ch.5.1.6
E714 Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray.
Ch.5.1.6
E721 Jam not reaching the read sensor: The original
does not reach the read sensor after it has passed
the registration sensor (when scanning obverse
side) or the reverse sensor (when scanning reverse
side).
Ch.5.1.6
E722 Jam not reaching the original exit/reverse sensor
(during scanning): The original which passed the
read sensor does not reach the original exit/reverse
sensor when it is transported from the scanning
section to exit section.
Ch.5.1.6
E724 Stop jam at the original registration sensor: The
trailing edge of the original does not pass the origi-
nal registration sensor after its leading edge has
reached this sensor.
Ch.5.1.6
E725 Stop jam at the read sensor: The trailing edge of the
original does not pass the read sensor after its lead-
ing edge has reached this sensor.
Ch.5.1.6
E731 Stop jam at the original exit/reverse sensor: The
trailing edge of the original does not pass the origi-
nal exit/reverse sensor after its leading edge has
reached this sensor.
Ch.5.1.6
E860 RADF jam access cover open: The RADF jam
access cover has opened during RADF operation.
Ch.5.1.6
E870 RADF open jam: RADF has opened during RADF
operation.
Ch.5.1.6
E910 Finisher jam
(Bridge unit)
Jam at the bridge unit transport sensor 1: The
paper does not reach the bridge unit transport sen-
sor 1 after it has passed the exit sensor.
Ch.5.1.7 [ 1 ]
E920 Stop jam at the bridge unit transport sensor 1: The
trailing edge of the paper does not pass the bridge
unit transport sensor 1 after its leading edge has
reached the sensor.
Ch.5.1.7 [ 1 ]
E930 Jam at the bridge unit transport sensor 2: The trail-
ing edge of the paper does not reach the bridge unit
transport sensor 2 after its leading edge has
reached the bridge unit transport sensor 1.
Ch.5.1.7 [ 1 ]
E940 Stop jam at the bridge unit transport sensor 2: The
trailing edge of the paper does not pass the bridge
unit transport sensor 2 after its leading edge has
reached the bridge unit transport sensor 2.
Ch.5.1.7 [ 1 ]
E9F0 Finisher jam
(Punch unit)
Punching jam: Punching is not performed properly.
[MJ-1023/1024 (when MJ-6004 is installed)]
Ch.5.1.7 [ 4 ]
Error code Classification Contents Troubleshooting
05/07