Filter
Top Products
June 2005 © TOSHIBA TEC e-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 9
2
CB20 Finisher related ser-
vice call
Delivery motor abnormality: Delivery motor or deliv-
ery roller is not rotating normally. [MJ-1022]
Ch.5.1.16
CB30 Tray 1/Tray 2 shift motor abnormality: Tray 1/Tray 2
shift motor is not rotating or delivery tray is not mov-
ing normally. [MJ-1023/1024]
Ch.5.1.16
CB40 Rear aligning plate motor abnormality: Rear align-
ing plate motor is not rotating or aligning plate is not
moving normally. [MJ-1023/1024]
Ch.5.1.16
CB50 Staple motor abnormality: Staple motor is not rotat-
ing or stapler is not moving normally. [MJ-1022/
1023/1024]
Ch.5.1.16
CB60 Stapler shift motor abnormality: Stapler shift motor
is not rotating or staple unit is not moving normally.
[MJ-1023/1024]
Ch.5.1.16
CB80 Backup RAM data abnormality:
1) Abnormality of checksum value on finisher con-
troller PC board is detected when the power is
turned ON. [MJ-1023/1024]
2) Abnormality of checksum value on punch con-
troller PC board is detected when the power is
turned ON. [MJ-1023/1024 (when MJ-6004 is
installed)]
Ch.5.1.16
CB90 Paper pushing plate motor abnormality: Paper
pushing plate motor is not rotating or paper pushing
plate is not moving normally. [MJ-1024]
Ch.5.1.16
CBA0 Stitch motor (front) abnormality: Stitch motor (front)
is not rotating or rotary cam is not moving normally.
[MJ-1024]
Ch.5.1.16
CBB0 Stitch motor (rear) abnormality: Stitch motor (rear)
is not rotating or rotary cam is not moving normally.
[MJ-1024]
Ch.5.1.16
CBC0 Alignment motor abnormality: Alignment motor is
not rotating or aligning plate is not moving normally.
[MJ-1024]
Ch.5.1.16
CBD0 Guide motor abnormality: Guide motor is not rotat-
ing or guide is not moving normally. [MJ-1024]
Ch.5.1.16
CBE0 Paper folding motor abnormality: Paper folding
motor or paper folding roller is not rotating normally.
[MJ-1024]
Ch.5.1.16
CBF0 Paper positioning plate motor abnormality: Paper
positioning plate motor is not rotating or paper posi-
tioning plate is not moving normally. [MJ-1024]
Ch.5.1.16
CC00 Sensor connector abnormality: Connector of guide
home position sensor, paper pushing plate home
position sensor or paper pushing plate top position
sensor is disconnected. [MJ-1024]
Ch.5.1.16
CC10 Micro switch abnormality: With all covers closed,
inlet door switch, delivery door switch or front cover
switch is open. [MJ-1024]
Ch.5.1.16
Error code Classification Contents Troubleshooting