Filter
Top Products
e-STUDIO281c/351c/451c FIRMWARE UPDATING June 2005 © TOSHIBA TEC
6 - 20
<Updating Finisher ROM>
Finisher firmware (MJ-1023/1024) and saddle stitcher firmware (MJ-1024 only) are written on the fin-
isher ROM. These two kinds of firmware can be updated individually by installing the download jig to
the finisher control PC board.
Remark:
The following updates are needed according to the finisher model.
• MJ-1023 (Console type):
Only the update of “Finisher firmware” is needed.
• MJ-1024 (Console type with the saddle stitcher):
Two kinds of update “Finisher firmware” and “Saddle stitcher firmware” are needed.
(1) Install the ROM to the download jig.
Make sure the direction is correct ( P.6-3 " K-PWA-DLM-320").
(2) Shut down the equipment.
(3) Take off the finisher rear cover.
Fig.6-16
* Connect the finisher interface cable with the equipment after removing the finisher rear cover.
Finisher rear cover Finisher rear cover
[
MJ-1023
][
MJ-1024
]