Filter
Top Products
4-44 [CONFIDENTIAL] TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784)
Installing the Cover assembly and Base assembly
To install the cover assembly and base assembly, follow the steps below and refer to Figure
4-23 to 4-25.
1. Place the cover assembly on the base assembly and secure them
screws.
with the following
2. Turn up the insulator (LCD CONN INSULATOR) and connect the LCD harness to
NOTE: Arrange the LCD harness under the guides.
M2.58B FLAT HEAD screw 5
M2.512B FLAT HEAD screw 3
the connector CN5300 on the system board.
3. Connect the FS board FFC and camera harness to the connector CN9550 and
CN9540 on the system board.
4. Turn over the computer and secure the cover assembly and base assembly with the
following screws.
M2.58B FLAT HEAD screw 11 (“8” in the Figure 4-23)
5. Connect the RGB harness and serial port FFC to the connector CN9510 and
CN9520 on the system board.
LCD harness
Guide
Guide
Guide