Filter
Top Products
Installing the System board
To install the system board, follow the steps below and refer to Figure 4-34.
1. Connect the DC-IN harness to the connector CN8800 on the back of the system
board.
2. Set the system board on the base assembly in place and secure them with the
following screws.
M2.55C Tapping screw 2
3. Set the DC-IN harness into the slot.
4. Connect the speaker harness to the connector CN6150 on the system board.
NOTE: When replacing the system board with a new one, stick the gasket on the system
board in place.
TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784) [CONFIDENTIAL] 4-61