Filter
Top Products
4.14 Touch pad/Fingerprint sensor board
Removing the Touch pad/Fingerprint sensor board
To remove the touch pad/fingerprint sensor board, follow the steps below and refer to Figure
4-26 to 4-28.
1. Turn up the insulator (TPAD LOW INSULATOR) and remove the following screws.
M2.03C S-THIN HEAD screw 4
2. Peel off the acetate tape.
3. Disconnect the FS board FFC, touch pad button FFC and dual button FFC from
the connector CN9650 and CN3240 on the fingerprint sensor board and connector on
the touch pad.
NOTE: In models without a dual button, there is no dual button FFC.
M2.0x3C
S-THIN HEAD
Insulator
(TPAD LOW
INSULATOR)
M2.0x3C S-THIN HEAD
A
cetate tape
CN3240
M2.0x3C S-THIN HEAD
Dual button FFC
FS board FFC
CN9650
Touch pad
button FFC
Figure 4-26 Removing the touch pad (1)
TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784) [CONFIDENTIAL] 4-45