Filter
Top Products
Installing the LCD unit
To install the LCD unit, follow the steps below and refer to Figure 4-46 to 4-51.
1. Set the brake hinges to the LCD unit and secure them with the following screws.
M2.03C S-THIN HEAD screw 2
2. Connect the LCD harness to the connector on the LCD unit and secure it with the
pull tape.
3. Arrange the LCD harness under the guides of the LCD cover.
4. Set the LCD unit on the LCD cover and secure them with the following screws.
M2.55C Tapping screw 4
NOTE: When securing the LCD unit and LCD cover, be sure to secure the screws in the
order of the number on the Figure 4-49.
5. Set the insulator (LCD HNS INSULATOR) under the LCD unit.
NOTE: When sticking the LCD HNS INSULATOR, as shown in the figure below.
6. Set the LCD mask to the LCD assembly while engaging the latches.
NOTE: When setting the LCD mask, be careful not to pinch the cables.
7. Secure the LCD mask with the following screws.
M2.55B FLAT HEAD screw 2
8. Stick the LCD mask cushions in place.
TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784) [CONFIDENTIAL] 4-93