Filter
Top Products
Installing and Removing Hardware
Expansion cards
104
Installing the SCSI riser card
WARNING: Do not touch any parts except those necessary
for installing the device. There are many high-voltage parts
that may cause an electric shock.
When installing or removing the expansion card, shut the
server down, switch off the power, and pull out the power plug
from the wall outlet. This may cause an electric shock.
CAUTION: It is advisable to wear gloves when installing or
removing the expansion card. Hands may be injured by
sharp objects on the optional boards or the server.
The following describes how to replace the SCSI riser card.
Install the expansion card as follows, while referring to the section
“Before starting operation” on page 48:
1 If the server is running, shut it down and switch off the power.
2 Unplug the power cable.
NOTE: Installing the expansion card while the power is on
may damage the server and expansion card.
3 Remove the server panels.
See “Removing and replacing the server panels” on page 54.
4 Remove two screws which fix the PCI bracket, then remove
one screw.