Toshiba Z300 Server User Manual


 
Getting Started
Starting up the system
36
Starting up by the hard disk drive unit (in the case the OS has
been installed)
To start up the server from the hard disk drive unit, proceed as
follows:
1 Make sure that neither the floppy disk nor CD-ROM that is
capable of starting up the server is in either drive unit.
2 Switch on the power/sleep button.
NOTE: The CD-ROM can be ejected from the CD-ROM drive
unit only when the system is on. Always remove the CD-
ROM from its drive unit before turning the system off.
If you are in doubt as to whether a CD-ROM is set in the CD-
ROM drive unit, check by pressing the eject button of the CD-
ROM drive unit. This procedure must be done while the
power-on self test is being performed once the power/sleep
button is turned on.
If the start up CD-ROM is placed in the CD-ROM drive unit,
the startup operation from the hard disk drive unit will result in
failure, even if the CD-ROM is ejected once the system is has
been switched on.