Toshiba Z300 Server User Manual


 
Installing and Removing Hardware
Memory module
77
Removing a memory module
Before removing a memory module, carefully read “Before start-
ing operation” on page 48 and proceed to the job following the
procedure mentioned below:
1 If the server is in operation, shut it down and switch off the
power.
2 Unplug the power cable from the AC outlet.
NOTE: Removing a memory module while the server is still in
operation could cause damage to the server and/or the mem-
ory module.
3 Remove the outer covers and server panels from the server.
See “Removing and replacing the server panels” on page 54.
4 Remove the power supply unit.
See “Power Supply Unit” on page 69
5 Extend the hooks on both sides of the memory slot outwards
and remove the memory module out of the slot.
When the hooks of the memory slot are extended outwards, the
memory module may occasionally spring from its slot. To
avoid this be sure to hold the memory module by hand when
removing.
Removing a memory module