Filter
Top Products
Installing Software
NetWare
180
(2) The CD-ROM drive is recognized by MS-DOS.
To make the MS-DOS recognize the CD-ROM drive, set up the
MS-DOS environment as mentioned in the preceding step (1) and
set the floppy disk labeled “DOS Disk” (created by the Toshiba
Server Setup Tool) on the floppy disk drive. Then, operate as
follows:
1 Create the directory XXX in the drive C for installing the CD-
ROM driver. The “XXX” is an arbitrary directory name.
2 Input “A:” and press the <Enter> key to shift it to the drive A.
3 Copy the “TEAC_CDI.SYS” from the DOS Disk in the drive
A to the XXX directory.
4 Add the following line to the first line of the “Config.sys.”
DEVICE=C:\XXX\TEAC_CDI.SYS /D:CD01 /P:P
5 Add the following line to the first line of the “Autoexec.bat.”
C:\DOS\MSCDEX.EXE /D:CD01 /M:15
6 Restart the system.
For installing NetWare 5.1 manually
Selecting the driver when installing NetWare 5.1
When the installation of NetWare 5.1 starts, the installer detects
the SCSI controller and the network adapter, and automatically
assigns drivers contained on the NetWare CD-ROM. However,
use the driver that comes with this system instead of these drivers.
Selecting the IDE RAID Controller driver
The installer detects the SCSI controller, and the following menu
appears.
Select “Modify,” and replace the driver according to the following
procedure: