Filter
Top Products
233
7 Remove the sever panels, power supply unit and board for
wireless card, and return the jumper switch to 3-4 short.
8 Install the board for wireless card, the power supply unit and
server panels.
9 Connect the AC power cable again and restart your server.
10 Start the BIOS Setup Utility, set System Time and System
Date and select “Load Setup Default” from the Exit menu to
execute it.
NOTE: The standard settings displayed after the original data
has been cleared are the initial data of the motherboard, and
they may differ from the defaults (recommended settings).
When the original data is cleared, password of the security
menu and data settings of the SCSI controller will also be
cleared.
Before clearing information, remove all expansion cards.
Recovery Boot
Perform the following operations if the recovery boot is needed:
1 Disconnect AC power cable.
2 Remove the server panles, power supply unit and board for
wireless card.
3 Set the jumper switch PJ723 on the motherboard of the server
to 2-3 short.
PJ723: 2-3 short ... Recovery Boot.
1-2 short... Normal Boot
4 Install the board for wireless card, power supply unit and
server panels, and connect the AC power cable.
5 Insert BIOS Recovery Diskette into floppy disk drive and turn
on the server. The recovery process will take a few minutes.