Filter
Top Products
Port Tab
This screen has 2 panels - Physical Port and Logical Port.
Physical Port
The following settings are available:
• Selected Physical Port - Select the Physical Printer Port you wish to configure.
• Handshake Signal - Select Busy Only or Busy & Ack for the Physical Port.
• Printer Type - Select High Speed or Low Speed for the Printer Type.
Logical Port
Logical Ports (printers) can be used in the Unix environment. The following settings are
available:
• Selected Logical Port - Select the Logical Printer Port you wish to configure.
• Map to Physical Port - Select the physical Printer Port which the Logical printer will use.
(By default, L1 is the parallel port, and L2 is the USB port)
• Convert LF to LF+CR - If checked, LF (line feed) characters are changed to CR+LF
(carriage return + line feed).
• Prefix of Job - The printer control string (in hex) to be sent to the printer before each print
job. This string cannot exceed 15 characters.
• Suffix of Job - The printer control string (in hex) to be sent to the printer after each print
job. This string cannot exceed 15 characters.
Figure 29: Port Screen
The Get Defaults button will reset all settings to their factory-default values.
Page 35