Filter
Top Products
LED Indicators
The Error LED is red. The Status indicator LED is green. The LED indicator modes are
described in the following table.
ACT LED
(Green)
ERR LED
(Red)
Status Description
Off Off No power.
On Off Normal operation - Idle.
Flashing Off Normal operation - transmitting or receiving
packets from the network.
On On Hardware error.
Flashing Flashing Firmware upgrade in progress.
LED Description
WLAN ACT
Off - No Wireless connection available.
On - Wireless connection available.
Flashing - Transmitting or receiving data via the Wireless LAN.
LAN ACT
Off - No LAN connection
On - LAN connection available.
Flashing - Transmitting or receiving data via the wired LAN.
Diagnostic Push Button
The Wireless Print Server is fitted with a Diagnostic Push Button. The button is recessed; a pin
or paper clip can be used to press it. This button has 2 functions:
• Restore the factory default settings
• Print a test page containing all current settings.
To restore the factory default settings:
1. Turn the Wireless Print Server OFF.
2. Press and hold the diagnostic button. While pressing the button, switch the Wireless Print
Server ON.
3. If you continue pressing the button for 10 seconds, a diagnostic page will be printed,
showing the new (default) settings.
To generate a Diagnostic print out
1. Ensure that both the Wireless Print Server and the printer attached to port 1 (parallel port)
are ON.
2. Press the diagnostic button, and hold it in for 2 seconds.
3. The test page, containing the current settings, will be printed.
Note:
PostScript printers are unable to print this page. If you have a PostScript printer on Port 1,
the test page will not be printed.
Page 4