Filter
Top Products
Other Features and Settings
131
Properties
• Destination Network - The network address of the remote LAN
segment. For standard class "C" LANs, the network address is
the first 3 fields of the Destination IP Address. The 4th (last)
field can be left at 0.
• Network Mask - The Network Mask for the remote LAN
segment. For class "C" networks, the default mask is
255.255.255.0
• Gateway IP Address - The IP Address of the Gateway or
Router which the TW100-BRV204 must use to communicate
with the destination above. (NOT the router attached to the
remote segment.)
• Interface - Normally, this will be "LAN". If NAT is disabled,
the "WAN" option can be used for Routers which are accessed
via the WAN port.
• Metric - The number of "hops" (routers) to pass through to
reach the remote LAN segment. The shortest path will be used.
The default value is 1.
Buttons
Save
Save the RIP setting. This has no effect on the Static Routing Table.
Add
Add a new entry to the Static Routing table, using the data shown in
the "Properties" area on screen. The entry selected in the list is
ignored, and has no effect.
Update
Update the current Static Routing Table entry, using the data shown
in the "Properties" area on screen.
Delete
Delete the current Static Routing Table entry.
Clear Form
Clear all data from the "Properties" area, ready for input of a new
entry for the Static Routing table.
Generate Report
Generate a read-only list of all entries in the Static Routing table.
Configuring Other Routers on your LAN
It is essential that all IP packets for devices not on the local LAN be passed to the TW100-
BRV204 , so that they can be forwarded to the external LAN, WAN, or Internet. To achieve
this, the local LAN must be configured to use the TW100-BRV204 as the Default Route or
Default Gateway.
Local Router
The local router is the Router installed on the same LAN segment as the TW100-BRV204 .
This router requires that the Default Route is the TW100-BRV204 itself. Typically, routers
have a special entry for the Default Route. It should be configured as follows.
Destination IP Address
Normally 0.0.0.0, but check your router documentation.
Network Mask
Normally 0.0.0.0, but check your router documentation.
Gateway IP Address
The IP Address of the TW100-BRV204 .
Interface
LAN
Metric
2