TRENDnet BRV204 Network Router User Manual


 
TW100-BRV204 User’s Guide
8
3. Connect WAN Cable
Connect the Broadband modem to the WAN port on the TW100-BRV204 . Use the cable
supplied with your Broadband modem. If no cable was supplied, use a standard LAN cable.
4. Power Up
Power on the Broadband modem.
Connect the supplied power adapter to the TW100-BRV204 and power up.
Use only the power adapter provided. Using a different one may cause hardware damage
5. Check the LEDs
The Power LED should be ON.
The Status LED should blink during start up, then turn Off. If it stays on, there is a hard-
ware error.
For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is
also ON.)
If a PC is connected to the DMZ port, the DMZ port's Link/Act LED should be ON (pro-
vided the PC is also ON.)
The WAN LED should be ON.
For more information, refer to Front-mounted LEDs in Chapter 1.