Filter
Top Products
Introduction
5
Rear Panel
Figure 3: Rear Panel
Reset Button
This button has two (2) functions:
• Reboot. When pressed and released, the TW100-BRV204 will
reboot (restart).
• Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
4. Release the Reset Button. The TW100-BRV204 is now using
the factory default values.
WAN port
(10/100BaseT)
Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
DMZ port
PCs or devices connected to the DMZ port are isolated from the
LAN.
If you have a server you wish to make available to the public, you
can connect it here. To use multiple servers, use a standard LAN
cable to connect the DMZ port to a normal port on another hub, and
connect your servers to the hub.
10/100BaseT
LAN connections
Use standard LAN cables (RJ45 connectors) to connect your PCs to
these ports.
Note:
Any LAN port on the TW100-BRV204 will automatically function
as an "Uplink" port when required. Just connect any port to a normal
port on the other hub, using a standard LAN cable.
Power port
Connect the supplied power adapter here.
Using the DMZ Port
The DMZ port is intended for connection of a server you wish to make available to the public.
To use multiple servers, use a standard LAN cable to connect the DMZ port to a normal port
on another hub, and connect your servers to the hub.
Please note the following points regarding the DMZ port.
• Although physically attached to the hub ports, the DMZ port is not part of the built-in hub.
It is a separate single port which is isolated from the hub.