Filter
Top Products
Microsoft VPN
75
Figure 50: VPN Wizard – General Screen
General Settings
Policy Name
Enter a suitable name. This name is not supplied to the remote VPN. It is
used only to help you manage the policies.
Enable Policy
Enable or disable the policy as required. For each remote VPN, only 1
policy can be enabled at any time.
Allow NetBIOS
traffic
Enable this if you require NetBIOS traffic to be transferred through the
VPN tunnel. NetBIOS is used by Microsoft (Windows) networking. This
setting should not be enabled unless necessary, because it increases
traffic volume.
Remote VPN
Endpoint
The Internet IP address of the remote VPN endpoint (Gateway or client).
• Dynamic. Select this if the Internet IP address is unknown. In this
case, only incoming connections are possible.
• Fixed. Select this if the remote endpoint has a fixed Internet IP
address. If selected, enter the Internet IP address of the remote end-
point.
• Domain Name. Select this if the remote endpoint has a Domain
Name associated with it. If selected, enter the Domain Name of the
remote endpoint.
Keys
Select Manually assigned or IKE (Internet Key Exchange) as required.
If you are setting up both endpoints, using IKE is recommended.
2. Click Next to continue. You will see a screen like the following: