Filter
Top Products
Microsoft VPN
77
Remote IP addresses
Type
• Single address - enter an IP address in the "Start IP address"
field.
• Range address - enter the starting IP address in the "Start IP
address" field, and the finish IP address in the "Finish IP ad-
dress" field.
• Subnet address - enter the desired IP address in the "Start IP
address" field, and the network mask in the "Subnet Mask" field.
The remote VPN should have these IP addresses entered as it's
"Local" addresses.
3. Click Next to continue. The screen you will see depends on whether you previously
selected "Manual Key Exchange" or "IKE".
Manual Key Exchange
Figure 52: VPN Wizard - Manual Key Exchange Screen
These settings must match the remote VPN. Note that you cannot use both AH and ESP.
Manually assigned Keys
AH Authentication
AH (Authentication Header) specifies the authentication protocol
for the VPN header, if used. (AH is often NOT used)
If AH is not enabled, the following settings can be ignored.
Keys
• The "in" key here must match the "out" key on the remote
VPN, and the "out" key here must match the "in" key on the
remote VPN.
• Keys can be in ASCII or Hex (0..9 A..F)
• For MD5, the keys should be 32 hex/16 ASCII characters.