Tripp Lite B064-032-04-IP Switch User Manual


 
8
Hardware Setup
Before You Begin
General Safety Instructions
• Readalloftheseinstructions.Savethemforfuturereference.
• Followallwarningsandinstructionsmarkedonthedevice.
• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life
support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence of a
flammable anesthetic mixture with air, oxygen or nitrous oxide.
• ThisdeviceisdesignedforITPowerDistributionsystemswithupto230Vphase-to-phasevoltage.
• Donotplacethedeviceonanyunstablesurface(cart,stand,table,etc.).Ifthedevicefalls,seriousdamagewillresult.
• Donotusethedevicenearwater.
• Donotplacethedevicenear,orover,radiatorsorheatregisters.
• Thedevicecabinetisprovidedwithslotsandopeningstoallowforadequateventilation.Toensurereliableoperation,andtoprotectagainst
overheating, these openings must never be blocked or covered.
• Thedeviceshouldneverbeplacedonasoftsurface(bed,sofa,rug,etc.),asthiswillblockitsventilationopenings.Likewise,thedeviceshould
not be placed in a built in enclosure unless adequate ventilation has been provided.
• Neverspillliquidofanykindonthedevice.
• Unplugthedevicefromthewalloutletbeforecleaning.Donotuseliquidoraerosolcleaners.Useadampclothforcleaning.
• Thedeviceshouldbeoperatedfromthetypeofpowersourceindicatedonthemarkinglabel.Ifyouarenotsureofthetypeofpoweravailable,
consult your dealer or local power company.
• Topreventdamagetoyourinstallationitisimportantthatalldevicesareproperlygrounded.
• Thedeviceisequippedwitha3-wiregroundingtypeplug.Thisisasafetyfeature.Ifyouareunabletoinserttheplugintotheoutlet,contact
your electrician to replace your obsolete outlet. Do not attempt to defeat the purpose of the grounding-type plug. Always follow your local/
national wiring codes.
• Donotallowanythingtorestonthepowercordorcables.Routethepowercordandcablessothattheycannotbesteppedonortrippedover.
• Ifanextensioncordisusedwiththisdevicemakesurethatthetotalampereratingofallproductsusedonthiscorddoesnotexceedthe
extension cord ampere rating. Make sure that the total of all products plugged into the wall outlet does not exceed 15 amperes.
• Tohelpprotectyoursystemfromsudden,transientincreasesanddecreasesinelectricalpower,itisrecommendedthatyouplugyourdevices
into a Tripp Lite surge suppressor, line conditioner, or uninterruptible power supply (UPS).
• Positionsystemcablesandpowercablescarefullytoensurethatnothingrestsonanycables.
• Whenconnectingordisconnectingpowertohot-pluggablepowersupplies,observethefollowingguidelines:
•Installthepowersupplybeforeconnectingthepowercabletothepowersupply.
•Unplugthepowercablebeforeremovingthepowersupply.
•Ifthesystemhasmultiplesourcesofpower,disconnectpowerfromthesystembyunpluggingallpowercablesfromthepowersupplies.
•Neverpushobjectsofanykindintoorthroughcabinetslots.Theymaytouchdangerousvoltagepointsorshortoutpartsresultinginarisk
of fire or electrical shock.
•Donotattempttoservicethedeviceyourself.Referallservicingtoqualiedservicepersonnel.
• Ifthefollowingconditionsoccur,unplugthedevicefromthewalloutletandbringittoqualiedservicepersonnelforrepair:
•Thepowercordorplughasbecomedamagedorfrayed.
•Liquidhasbeenspilledintothedevice.
•Thedevicehasbeenexposedtorainorwater.
•Thedevicehasbeendropped,orthecabinethasbeendamaged.
•Thedeviceexhibitsadistinctchangeinperformance,indicatinganeedforservice.
•Thedevicedoesnotoperatenormallywhentheoperatinginstructionsarefollowed.
• Onlyadjustthosecontrolsthatarecoveredintheoperatinginstructions.Improperadjustmentofothercontrolsmayresultindamagethatwill
require extensive work by a qualified technician to repair.
• DonotconnecttheRJ11connectormarked“UPGRADE”toapublictelecommunicationnetwork.