Filter
Top Products
114
Using Tone-Out
• FM - the scanner uses FM (frequency
modulation) for the frequency band.
• NFM - the scanner uses narrowband FM for
the frequency band.
Note: The default setting is Auto.
Set Attenuator Turn the scroll control to
select On or Off.
• Set Tone Lets you set the tone-out type.
Edit Tone A - Enter the frequency (in Hz) for
Tone A
Edit Duration A - Enter the duration (in ms)
for Duration A. 500 ms is the default.
Edit Tone B - Enter the frequency (in Hz) for
Tone B
Edit Duration B - Enter the duration (in ms)
for Duration B. 300 ms is the default.
Tone Gap - Enter the tone gap (in ms). 100
ms is the default.
• Set Delay Time Enter a value from 1-5 or Off,
then press the scroll control.
• Set Alert
Alert 1 - 9 select the type of alert you want
the scanner to sound when it receives an alert.
• Level 1 - 15 - the scanner adjusts the vol-
ume you hear to the level you select.
• Auto - the scanner automatically sets the
alert beep to the master volume level.
Off - the scanner does not sound an alert.
BCD396T Paper OM.fm Page 114 Wednesday, March 30, 2005 8:36 PM