Uniden BCD396T Scanner User Manual


 
58
Other Settings
(Master scanner) Clone Master Press SCAN Key
(Slave scanner) Clone Slave Press SCAN Key
When you are ready to clone the scanner, press
on the slave scanner first, then on the master scanner.
The master scanner checks the connection between the
two scanners, then transfers its data to the slave scanner.
When the transfer is complete, Complete appears on
both scanners. If the transfer did not work, Error
appears on the master scanner.
On-Air Cloning
You can clone (copy) data from a PC to a BCD396T
scanner. This is useful if you want to quickly program
20 or more BCD396T scanners at the same time.
Xfer Information
On-Air Clone
Start Cloning Start on-air cloning.
Set Frequency Lets you set the frequency where
your scanner receives the cloning broadcast.
Set Modulation Lets you set the cloning
broadcast’s modulation type.
To clone data from a PC to the scanner, you need a
transceiver, a PC that has an audio input, and a cable
to connect your PC’s sound card to the transceiver.
Follow the directions supplied with the Uniden
Advanced Scanner Director Software (available online
at http://www.uniden.com) to construct a cable and
use on-air cloning.
When you are receiving the cloning broadcast and are
ready to clone the scanner, select Start Cloning
on the scanner. The scanner receives the data from
the transmission
When the transfer is complete, Complete appears. If
the transfer did not work, Error appears.
Scan
Scan
Scan
Menu
BCD396T Paper OM.fm Page 58 Wednesday, March 30, 2005 8:36 PM