Filter
Top Products
EF4270 Emulation Commands
3255 4073–002 9–5
Line Feed
Prints the data in the buffer and feeds the paper one line. The height of the line
is determined by the internal DIP switch settings or by the Set Up Parameters
command (19 n). See “Chapter 3: Diagnostics and Print Test” for more
information.
Hexadecimal Decimal ASCII
0A 10 LF
Vertical Tab
Prints any data in the buffer and then advances the paper .02083 inches
(0.523mm).
Hexadecimal Decimal ASCII
0B 11 VT
Eject Slip
Feeds the slip until the lower sensor is uncovered. The printer enters roll mode.
Even if the printer is selected for concurrent feed, only the cut sheet is ejected.
After the command is executed, the rolls remain closed until an Document
Clamp Open (1B 0C) command is received.
Hexadecimal Decimal ASCII
0C 12 FF
Carriage Return
Prints the data in the buffer and advances the paper if Auto Line Feed is
enabled either by the internal DIP switch settings or by the Set Up Parameters
command (19 n). See “Chapter 3: Diagnostics and Print Test” for more
information.
Hexadecimal Decimal ASCII
0D 13 CR