Filter
Top Products
66
OSD (On Screen Display) Controls
4. Once the setting is completed ...
Press the EXIT button to return to the main menu. To delete the
main menu, press the EXIT button once more.
Loop Out Setting
When this feature is set to ON, the received signal will be
looped out.
Example: Setting “ON”
Perform the following operations.
Press the MENU button on the remote control to display the
MAIN MENU on the screen, then...
1. Use the and buttons to select “SETTING 3”, then press
the MENU button. The “SETTING 3” screen appears.
2. Use the and buttons to select “LOOP OUT”.
3. To set the LOOP OUT to “ON”...
Use the and buttons to select “ON”.
The mode switches as follows each time the or button is
pressed: OFF ON
Information
■ IR ENABLE settings
ON ........ Enables remote control wireless transmission.
OFF ....... Disables remote control wireless transmission. Set “OFF”
to avoid unwanted control from other remote controls.
■ Restoring the factory default settings
Select “FACTORY” under the SETTING 1 menu.
Note that this also restores other settings to the factory defaults.
TIMER
INPUT SELECT : LAST
CONTROL LOCK : ON
IR ENABLE : OFF
LOOP OUT : ON
ID NUMBER : ALL
VIDEO WALL
SETTING 3 3 / 3
PREVIOUS PG.
SEL. ADJ. EXIT
EXIT
Information
■ LOOP OUT settings
ON ........ The received signal will be looped out via
PC1 terminal or VIDEO1 terminal.
OFF ....... The received signal will not loop out.
* Even if LOOP OUT is ON, signals would
not be sent out if POWER is being turned off.
■ To connect to another display...
See page 68.
■ If the RGB/PC1 signal is present at the time
the power is switched on...
The RGB/PC1 input will be displayed regardless
of the setting of LOOP OUT.
■ Restoring the factory default settings
Select “FACTORY” under the SETTING 1 menu. Note that
this also restores other settings to the factory defaults.