Filter
Top Products
Installation
Load Connection
Release 2.1 47
Output Cover The power supply comes with a bus bar cover and strain relief. See
Figure 2.4. This cover is also installed on models fitted with the high voltage output
connector.
To detach the 2-part cover:
1. Undo 6-32 x 5/16 in. Phillips pan head screws, 6 x 0.288 in. lock washers, and 6
x 5/16 in. flat washers (3 places) from the top cover.
2. Pull up on the top cover to remove it.
3. Undo 6-32 x 1/4 in. Keps nuts and 6 x 5/16 in. flat washers from the
chassis-mounted PEM studs (3 places) to remove the chassis cover.
Figure 2.4 Output Strain Relief and Cover
Screw, Lock
Washer, and Flat
Washer
(3 places)
Keps Nut and
Flat Washer
(3 places)
Wire Clamp
and Screw
Strain Relief
Chassis Cover
Top Cover