Filter
Top Products
Local Operation
Standard Operation
Release 2.1 59
Shipped
Configuration
(Local Control
Mode)
The factory ships units already configured for local control (front panel) operation.
See Table 3.1 for a summary of this configuration. See Figure 1.1 and Figure for
front and rear panel diagrams.
Table 3.1 Shipped Configuration (Local Control Mode)
Local Control Configuration Additional References
Use the front panel controls to adjust the
output voltage and current limit settings.
(Note: Use the LOCAL button only when you
have a digital programming interface
installed.)
See Section 3 for front panel operation.
See Section 4 for remote analog
programming procedure(s).
The supply's sense point is at the rear panel
J10 sense connector terminals.
See
“Local and Remote Sensing” on
page 53
for how to change from local to
remote sensing.
The OVP set point is adjusted at the front
panel to approximately 110% of rated output
voltage.
See
“Using Over Voltage Protection
(OVP)” on page 61
for the adjustment
procedure.
The over temperature shutdown function
automatically resets when activated as
determined by the position of rear panel
switch SW1-8. A latch off setting is also
available.
See
“Over Temperature Protection
(OTP)” on page 70
for more
information about switch SW1-8
settings.