Filter
Top Products
CONTROLLER SPECIFICATIONS AND REQUIREMENTS
XEROX DOCUPRINT NETWORK PRINTER SERIES INSTALLATION PLANNING GUIDE FOR MODELS 96/4635/180 NPS 5-3
Space requirements
This section provides recommendations for placement of printer
controller hardware components.
For printer component space requirements, refer to the “Printer
specifications and requirements” chapter of this guide. Contact your
service representative if you have questions not specifically
addressed in this guide.
Printer controller placement
You should consider the following factors when deciding where to
place the DocuPrint printer controller:
• Adequate work space and service clearance around the
equipment
• Proximity to electrical and network connectors
• Security of the work area. You may need to place the system in
an area where you can restrict access to it.
You must supply a table or desk as a work surface for the printer
controller. The top of the table must provide at least 36 by 36 inches
/ 91.4 by 91.4 cm of space for each component, to allow enough
space for the components and cables, as well as for service access.
Refer to the “Printer controller specifications and requirements”
summary table at the end of this chapter to make sure the tables you
supply can support the weight of the printer controller hardware
elements, and that they are suitable for the intended use.
!
Warning: The printer controller must be positioned within the line-
of-sight of the printer for safety purposes while servicing the
equipment.
Caution: Position the table at least 6 inches / 15.2 cm from the wall.
Make sure the printer controller processor is at least 12 inches /
30.4 cm from the wall. Do not put the processor on the NPS
printer.
!