Filter
Top Products
CONTROLLER SPECIFICATIONS AND REQUIREMENTS
5-8 XEROX DOCUPRINT NETWORK PRINTER SERIES INSTALLATION PLANNING GUIDE FOR MODELS 96/4635/180 NPS
Printer controller hardware specifications and requirements summary
The following table summarizes the specifications and electrical
requirements of your DocuPrint NPS printer controller hardware
components.
For a summary of printer hardware specifications and requirements,
refer to the “Printer specifications and requirements” chapter of this
guide. Contact your service representative if you have questions not
specifically addressed in this guide.
Table 5-3.96/4635/180 NPS printer controller specifications and
power requirements
Device
Dimensions (width,
height, depth) Weight
Heat
dissipation Power requirements Cable lengths
Processor W=16.4 in. (42 cm)
H=3 in. (8 cm)
D=16.1 in. (41 cm)
27 lbs.
(12.7 kg)
1,100 BTU
per hour
Sun Ultra 2 (60 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA,
5-15R NEMA
Sun Ultra 2 (50 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA
Sun Ultra 60 (60 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA,
5-15R NEMA
Sun Ultra 60 (50 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA
Power: 8 ft.
(2.1 m)
Interface to printer:
20 ft. (6.1 m)
total length
Monitor W=18.1 in. (46 cm)
H=17.7 in. (45 cm)
D=16.1 in. (41 cm)
61 lbs.
(27.7 kg)
408 BTU per
hour
100-120 VAC,
1 phase, 50-60 Hz,
3.0 amp, 0.4 KVA
200-240 VAC,
1 phase, 50-60 Hz,
2.0 amp, 0.4, KVA
Power: 8 ft.
(2.1 m)
Video cable to
processor:
46 in. (1.17 m)
Quarter-inch
cartridge tape
drive, 150 MB
(optional)
W=9.6 in. (24 cm)
H=2.8 in. (7 cm)
D=10.4 in. (26 cm)
7 lbs.
(3.18 kg)
--- 100-120/200-240
VAC, 0.8/0.4 amp,
47-63 Hz
SCSI cable to
processor or
additional SCSI
device: 28 in. (71
cm)
4 mm
cartridge tape
drive
(optional)
W=7.5 in. (19 cm)
H=2.8 in. (7 cm)
D=12.2 in. (31 cm)
8 lbs.
(6.6 kg)
--- 100-120/200-240
VAC, 0.8/0.4 amp,
47-63 Hz
SCSI cable to
processor or
additional SCSI
device: 28 in. (71
cm)
Keyboard W=18 in. (45.7 cm)
D=7.5 in. (17.8 cm)
2 lbs.
(1 kg)
--- --- 72 in. (1.8 m)