Filter
Top Products
Installation Planning Guide 8-1
8. Installation
This chapter describes the activities performed by you and Xerox
during the installation of the Xerox DocuColor 2060 NPS/IPS
hardware and software components. Before installation can
begin, you must complete the tasks described in the “Preparing
for installation” chapter of this guide.
Installation process
Xerox is responsible for the physical installation of the DocuColor
2060 NPS/IPS hardware components and the software.
For customers outside the United States, contact your local
Xerox representative or operating company for your specific
installation process.
The installation process can take one or several days to
complete. Equipment, software kits, and documentation kits may
all arrive in one day, or over the course of several days. When all
of the necessary items are in place, Xerox personnel will
complete the installation of the DocuColor 2060 NPS/IPS
components.
In the United States, the steps in the installation process typically
occur in the following order:
1. Xerox personnel installs all NPS/IPS printer hardware and
connects the printer controller to your network through the
Ethernet and Token Ring connector you supply. This process
takes approximately four hours if all the necessary network
and electrical connectors are in place.
2. Xerox personnel places the system online.
3. Xerox personnel loads printer controller software on the
printer controller (approximately 1.5 hours).