Filter
Top Products
Defining the printer to the host: TCP/IP attachment
Installation Planning Guide F-7
COPYMARK J Installation
preferences
N or J or C C: printer will offset-
stack or stitch on a
dataset copy basis.
J: Printer is to
increment offset
stacking or stitching on
a job boundary.
N: Copymarks are
constant, and no offset
stacking or stitching is
done.
DGROUP None Installation
printer
destination
naming
conventions
1 to 8-character
alphanumeric
string
Specifies destination
processed by this FSA
(applicable only if D is
specified in the WS
parameter).
DTYPE None PRTAFP1 PRTAFP1 Required parameter
DYNAMIC NO Installation
printer name
standards
YES or NO DYNAMIC=NO should
be specified so JES3
will keep FSA active
between transmission
of datasets.
FSSNAME None Name of FSA
in JNAME
parameter
1 to 8-character
alphanumeric
string
Must match value in
FSSNAME parameter
of FSSDEF statement.
JNAME None FSSNAME
parameter of
FSSDEF
statement
1 to 8-character
alphanumeric
string
Must match value in
FSSNAME parameter
of FSSDEF statement.
JUNIT ON See
comments.
(Device address,
Main, dest class,
ON/OFF)
Device address should
not be specified for
TCP/IP printers.
Main is name of
processor the FSS is to
run on.
Dest class is
destination class for
FSA messages.
ON or OFF specifies
whether FSA is initially
online or offline.
MODE None Must be FSS. FSS MODE=FSS must be
specified.
Table F-3. JES3 FSS statement parameters (Continued)
Item
description Default
Source of
value
Range of
acceptable
values Comments
Your
value