Xerox 2060 Copier User Manual


 
Defining the printer to the host: TCP/IP attachment
Installation Planning Guide F-9
4. Configure the printer in PSF/MVS
Follow these steps to configure the printer in PSF:
1. Locate the PSF startup procedure in the JES3 or JES2
startup JCL procedure. This is normally kept in
SYS1.PROCLIB, although your system may use a different
library.
The libraries specified by the //PROC00 DD statement
normally contains startup procedures for PSF subsystems.
The name of the procedure is specified in the initialization
dataset (FSS statement PROC parameter in JES2; the
FSSDEF statement PNAME parameter in JES3. See the
appropriate section in this appendix for clarification).
2. Add a PRINTDEV statement to define the printer in PSF.
(See the example below for the general format or the
Print
Services Facility for OS/390 Customization
for more
information.)
The table below contains descriptions of the PSF parameters
which need to be set for the printer.
Table F-5. PSF/MVS PRINTDEV statement parameters
Item
description Default
Source of
value
Range of
acceptable
values Comments
Your
value
APPLID None VTAM APPL
statement
1 to 8-character
alphanumeric
string
Not applicable for TCP/
IP-attached printer
BUFNO N/A 5 to 100 Not applicable for TCP/
IP-attached printer
FAILURE Installation
preferences
WCONNECT or
STOP
If printer is used by other
hosts, WCONNECT
causes PSF to
continuously retry to
establish connection with
printer.
FDEFDD None Installation
preferences
1 to 8-character
alphanumeric
string
Name of the form
definition library DD
statement
FONTDD None Installation
preferences
1 to 8-character
alphanumeric
string
Name of font library DD
statement. Fonts in this
library must match
resolution the printer is
using.