Filter
Top Products
Defining the printer to the host: TCP/IP attachment
F-8 Installation Planning Guide
NOTE: The WS parameter CL specifies that datasets with
the same class as the WS parameter should be selected. D
specifies that only datasets with the same destination as the
DGROUP parameter should be selected. F specifies that
JES3 is to pass the forms value specified on the DD or
OUTPUT JCL statement to the FSA.
Following is an example of the JES3 initialization dataset
required commands:
WC Any class
selected
Installation
output class
standards
List of
alphanumeric
output classes,
each separated
by a comma
If CLASS is specified in
the Work-selection
criterion in the WS
parameter, the FSA
selects datasets that
match values specified
here.
WS Installation
preferences
(see note)
Work-selection
criterion
Consider CL, R, and F.
See Note below and
JES3 Initialization and
Tuning Reference
manual for more
information.
Table F-3. JES3 FSS statement parameters (Continued)
Item
description Default
Source of
value
Range of
acceptable
values Comments
Your
value
Table F-4. JES3 initialization dataset commands example
FSSDEF TYPE=WTR,FSSNAME=FSSTCP1,PNAME=FSSPROC1,SYSTEM=SYS1,TERM=NO
DEVICE DTYPE=PRTAFT1,JNAME=PRT7,JUNIT=(,SYS1,,OFF),FSSNAME=FSSTCP1,
DGROUP=LOCAK, MODE=FSS,PM=(LINE,PAGE,SOSI1),WC=(T),WS=CL,D,F)